Camshafts - at last!

[JohnF]

Hi guys;

I received a shipment of 5 each camshafts for the 6/1 and 12/2 Listeroids.  These are the ones that have been properly set up and indexed and are expected to be accurate within a couple of thou.  Unfortunately I had to use cams provided by India that were already drilled, the cams have been re-drilled accurately at 90 degrees to the ori9ginal holes (much smaller pin!).

Prices are $210 for a 6/1  and $255 for a 12/2 plus shipping.  Peace of mind knowing that your engine will not fail due to faulty cam placement!  There are only 3 left of each right now but I should be able to get more now the production problem are ironed out.

Email me at john@woodnstuff.ca

[mike90045]

What's the hardening on the cams like ?  Did they drill like butter ?

[cujet]

I know the cam timing is slightly different for the higher RPM Listeroids such as the 8/1 and 16/2 and up. Do you have any cams for the higher RPM ones?

[JohnF]

Everything was way off on hardening, all parts have now been hardened correctly.  Don't have anything specific for the higher speed engines but these shafts may do well in them.

[Horsepoor]

Some large differences according to this: