Changing ST from 220 volts to 115 volts

[akghound]

Just checking to be sure. Currently my ST-15 is set up for 220 volts. However I would like to switch it over to 115 volts. From what I understand all I have to do is remove the jumper from U5-U6 and place jumpers between U1-U6 and U2-U5.
Currently I draw power from U1 and U2 with the U5-U6 jumper being Neutral.
On a 110 setup which terminal is Neutral and which is Hot (115)
Thanks .... Ken Gardner

[Shipo]

Ken go to  eBay item number  150351088776 and see  the last picture

from one of our member in this forum "akatosborne"

Hope this help

Sipo

[akghound]

As far as I can tell he only shows the 220/110 volt arrangement. I would like to see the 110 only setup. Still not sure which term would be hot or which would be neutral. I believe the 110 would be between U1 and U2.
Thanks ..... Ken Gardner

[Shipo]

Pick one doesn't matter. Read more here....

http://www.utterpower.com/installa.htm

[akghound]

Thank You.   
I got it!
I looked for that page this morning and couldn't find it.
Will have her changed to 110 before the cold hits tomorrow.
Thanks again ... Ken

[Shipo]

No problems good luck tomorrow..