Micro CoGen.

Thanks, will look at those.

What did you use for seats (ie what material/supplier)?

Thanks!

Quote from: playdiesel on August 05, 2020, 07:18:24 PM
Valve seats are something that India does a very poor job. The typical seat is 2X wider than the valve face. while it will get an engine out the door it won't seal for very long.
I cut out the old seat, counter bore and install hard seats with K-Line tooling.

What is the K-Line tooling you're using there? I took a look on their site and it seems like the pieces under counter boring are all for doing cylinder boring or re-sleeving?

This a great thread that you posted here. I have a 2-24 listeroid that has been sitting here for years that I'm just going back to work on the teardown. Your work is very inspirational!