Print Page - Changing ST from 220 volts to 115 volts

Title: Changing ST from 220 volts to 115 volts
Post by: akghound on October 08, 2009, 11:09:25 AM

Just checking to be sure. Currently my ST-15 is set up for 220 volts. However I would like to switch it over to 115 volts. From what I understand all I have to do is remove the jumper from U5-U6 and place jumpers between U1-U6 and U2-U5.
Currently I draw power from U1 and U2 with the U5-U6 jumper being Neutral.
On a 110 setup which terminal is Neutral and which is Hot (115)
Thanks .... Ken Gardner

Title: Re: Changing ST from 220 volts to 115 volts
Post by: Shipo on October 08, 2009, 01:44:26 PM

Ken go to eBay item number 150351088776 and see the last picture

from one of our member in this forum "akatosborne"

Hope this help

Sipo ;)

Title: Re: Changing ST from 220 volts to 115 volts
Post by: akghound on October 08, 2009, 02:26:21 PM

As far as I can tell he only shows the 220/110 volt arrangement. I would like to see the 110 only setup. Still not sure which term would be hot or which would be neutral. I believe the 110 would be between U1 and U2.
Thanks ..... Ken Gardner

Title: Re: Changing ST from 220 volts to 115 volts
Post by: Shipo on October 08, 2009, 02:33:01 PM

Pick one doesn't matter. Read more here....

http://www.utterpower.com/installa.htm

Title: Re: Changing ST from 220 volts to 115 volts
Post by: akghound on October 08, 2009, 02:57:25 PM

Thank You.
I got it! :)
I looked for that page this morning and couldn't find it.
Will have her changed to 110 before the cold hits tomorrow.
Thanks again ... Ken

Title: Re: Changing ST from 220 volts to 115 volts
Post by: Shipo on October 08, 2009, 03:10:01 PM

No problems good luck tomorrow.. :)

Micro CoGen.

Alternators and Generators => ST and STC generators => Topic started by: akghound on October 08, 2009, 11:09:25 AM