Xantrex no longer makes the generator start module for the SW5548+ but I found the pinout here: http://www.wind-sun.com/ForumVB/showthread.php?13831-Generator-Start-Module-for-SW-Plus-4024
I have already installed automotive relays on the start and stop signals to the generator so I can start/stop it from the house manually which has been working fine, I provide +12v from the house with a transformer and send it down to the generator through some CAT5.
I've managed to get the generator to start but can't figure out the the stop relay ( RY8 )
What are common, NO and NC? Common is the negative terminal?
It says common but there is no common on the pinout?
Since I don't seem to need pins 1 and 6 I can just use a RJ11 instead of a full RJ25 jack?
The RJ11 jack I have hooked up has:
Black
Red
Green
Yellow
Can some one help me figure out what to hook where?
Thanks!!
-Jedon
I have already installed automotive relays on the start and stop signals to the generator so I can start/stop it from the house manually which has been working fine, I provide +12v from the house with a transformer and send it down to the generator through some CAT5.
I've managed to get the generator to start but can't figure out the the stop relay ( RY8 )
Quote
Pin 1 and pin 2 are 12V Power supply to the GSM
Pin 3: RY7 signal
Pin 4: RY8 signal
Pin 5: RY11 signal
Pin 6: not used
RY7 is used for ignition enable/disable, or glow/stop with a diesel. This is set in Menu Heading 25 under 25A, depending on whether you select the GS, RN1 or RN2. GS (Glow/Stop) provides a momentary glow plug and stop signal to RY7, RN1 provides a continuous RY7 signal for engines that require ignition "on".
Cranking is provided by RY8.
RY11 is an alarm relay.
All three relays in the GSM have a common, NO and NC terminal.
What are common, NO and NC? Common is the negative terminal?
It says common but there is no common on the pinout?
Since I don't seem to need pins 1 and 6 I can just use a RJ11 instead of a full RJ25 jack?
The RJ11 jack I have hooked up has:
Black
Red
Green
Yellow
Can some one help me figure out what to hook where?
Thanks!!
-Jedon